VelocityAP Performance Exhaust Manifolds/Headers for Aston Martin V8 Vantage - Inconel 625

VEL-AMV8HEADERSINCONEL

Stock: Backorder Available

RRP AU$11,769.00

AU$8,826.75 Inc GST

Save: AU$2,942.25 - 25% OFF

Description

Description

VelocityAP offers performance exhaust manifolds and headers constructed entirely from Inconel 625, a material renowned for superior strength and tensile properties at high temperatures and used in Formula 1 exhaust manifolds.

The original Aston Martin manifolds are highly restrictive and manufactured to a cost, sacrificing horsepower and torque. VelocityAP tailored its design to work with the brand's 200-cell sport catalysts and unlock the engine's performance potential.

Some competing products advertise equal-length primaries despite having as much as 85 mm difference in length. VelocityAP manifolds use identical-length primaries for optimum power and torque increases, despite the additional design complexity. Each primary pipe can be measured to verify its length.

In addition to millimetre-perfect primary lengths, VelocityAP manifolds use a fully fabricated merge collector rather than a less costly formed or pressed collector that does not merge the 4 exhaust-gas flows equally and can reduce power. Product photos show the knife-edged internal structure, workmanship and attention to detail incorporated into each set.

The manifolds were independently performance-tested on a Dyno Dynamics rolling road with VelocityAP 200-cell sport catalysts, a performance exhaust system and an ECU tune. Dyno Dynamics systems are known for accuracy and consistency as well as relatively low readings. The customer's vehicle produced a baseline peak figure of 335.5BHP. Following installation of the manifolds, sport catalysts, exhaust system and ECU tune, peak output increased to 378.8BHP-a gain of 43.3BHP or 12.9%.

Because Dyno Dynamics systems are known for low readings, VelocityAP states that these results represent a BHP gain greater than 43.3BHP. The manufacturer's stated output for the 4.3L V8 Vantage is 380BHP. A 12.9% increase over this figure represents a gain of 49BHP and flywheel output of 429BHP.

Torque increased by 35-40ft/lbs from 4000RPM onwards, an improvement of approximately 13-15%. The manufacturer's stated maximum output is 302ft/lbs @5500RPM. VelocityAP estimates the test vehicle's true flywheel torque at approximately 345-350ft/lbs. This is a particularly significant improvement, reducing the need to downshift to access the torque band. VelocityAP states that the tested 4.3L vehicle will now outrun a later 4.7L vehicle.

VelocityAP expects similar results on 2009-on 4.7L vehicles.

Specifications

  • Primary diameter: 40 mm (initial)
  • Secondary diameter: 70 mm
  • Catalyst flange diameter: 76 mm
  • Primary length: 400 mm each, identical

Fitment

Fitment

  • Aston Martin V8 Vantage, all variants, 2006-2010 model years
  • Aston Martin V8 Vantage, all variants, 2011 model year onwards, when fitted in conjunction with VelocityAP 200 cell sports catalysts
  • Product Question

To top